例句與造句

1. The maximal tension stresses in surface and base between induced crack have been obtained by parametric analysis
   通過結構參數分析掌握了預切縫間面層、基層中最大拉應力的分布規律。
2. Then , taking the maximal tension stress in surface and base and the stress intensity factor at the top of the induced crack as restraining indexes , method to determine the reasonable induced spacing has been determined
   然后以預切縫上端應力強度因子、面層與基層內的最大拉應力為約束指標建立了合理預切縫間距的確定方法。
3. After a maximal response to kc1 was obtained under an initial tension of 2 g , isometric contractions induced by iron or pe were measured , and calculated as percentage of the maximal tension induced by kc1 . the rings with or without endothelium were preconstricted with 10 " 6mol / l of pe and a cumulative concentration - response curve to ach , or sodium nitroprusside ( snp ) , or l - arginine ( l - arg ) was obtained
   用10 ~ ( - 6 ) mol lpe預收縮后，加入不同濃度的ach 、硝普鈉( snp )或l -精氨酸( l - arg ) ，浙江大學碩士學位論文以各種濃度所致的舒張幅度達到pe所致的收縮幅度的百分比作血管舒張反應的量效曲線。
4. It's difficult to find maximal tension in a sentence. 用maximal tension造句挺難的